Wednesday, March 22, 2017

Cisco Prime Infastructure

Definition:
Cisco Prime Infrastructure is a network management tool that supports lifecycle  management of your entire network infrastructure from one graphical interface.
Provides network administrators with a single solution for provisioning, monitoring, optimizing and troubleshooting both wired and wireless devices.

Configuring SNMP
To ensure Prime Infrastructure can query SNMP devices and receive traps and notifications:

Step 1
Set SNMP credentials (community strings)  on each device you want to manage using Prime Infrastructure.
Configure  these devices to send SNMP notifications to the Prime Infrastructure.

admin(config)#snmp-server community private RW
admin(config)#snmp-server community public RW

NB
Where private and public are the community strings you want to set.

After you set the community strings you can specify the device notifications to be sent as traps to the Prime Infrastructure server using the following Cisco  IOS global command:

admin(config)#snmp-server host Host traps version community notification type

Host is the IP address of Prime Infrastructure server

Version is the version of SNMP that is used to send the traps

Community is the community string sent to the server with the notification operation.

Notification type is the trap to send

IPsec Site to Site VPN

IPsec Site to Site VPN: Definition

  • organizations use virtual private networks (VPN) to create end-to-end private network connection (tunnel) over third party networks such as the internet or extranets.
  • IP Security (IPsec) protocol provides a framework for configuring secure VPNs and is commonly deployed over the internet to connect branch offices, remote employees and business parties.
IPsec VPN negotiation can be broken down in five steps:

Step 1
An IPsec tunnel is initiated when Host A sends interesting traffic to Host B.
Traffic is considered interesting when it travels between the IPsec peers and meets that criteria that is defined in the crypto access control list.

Step 2
Router 1 and Router 2 negotiate a Security Association (SA) used to form an IKE Phase 1 tunnel which is known as an ISAKMP tunnel.

Step 3
Within the protection of the IKE Phase 1 tunnel an IKE Phase 2 tunnel is negotiated and set up. (IPsec Tunnel).

Step 4

After the IPsec tunnel is established interesting traffic flows through the protected IPsec tunnel.

Step 5
After no interesting traffic has been seen for a specified amount of time or if the IPsec SA is deleted, the IPsec tunnel is torn down.

Elements of site-to-site VPN
a) Headend VPN device - Act as a VPN termination device, located at a primary network location (Headquarters location).
b) VPN access device - Serves as a VPN termination device, located at a remote office.
c) Tunnel - Provides a logical connection over which traffic flows (e.g IP sec tunnel and Generic Router Encapsulaiton (GRE))
d) Broadband service - Transports traffic to and from the internet.

NB
IPsec operates at layer 3 of the OSI model  (Network Layer) and it is indepent of the applications.
It means that the applications don't require any modifications to use IPsec

IPsec Modes

1) Transport Mode - security is provided for the transport layer.
2) Tunnel mode - will encapsulate the original IP header and create a new IP header that is sent unencrypted across the untrusted network.

IPsec Transforms
IPsec delivers data confidentiality services by executing a "transform" on plain text data into a block of ciphertext.
Common ciphers used in the IPsec transforms are: DES, 3DES and AES.
3DES and AES are considered stronger encryption ciphers than DES.
3DES uses 128 bit key
AES uses 256 bit key